Richter GUT/F Series Overflow Valves Manual do Utilizador Página 8
- Página / 20
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Series GUT/F Page 8
9530-071-en Revision 10
TM 8361 Edition 10/2011
6 Installation
The installation conditions to the AD 2000 Code
A2 (on pressure vessels) and TRD721 are to be
observed. They are major preconditions for the
safe operation of the valve.
Examine valve for in-transit damage and do not
install any damaged overflow valves.
Before installation the valve and the connecting
pipe must be carefully cleaned to remove any dirt,
especially hard foreign matter.
During installation, pay attention to the correct
tightening torque, aligned pipes and tension-free
assembly.
6.1 Sizing of the outlet line
The admissible pressure loss in the inlet line
must not exceed 3% of the set pressure of
the overflow valve.
The determination of the pressure loss relates to the
maximum flow of the valve at 110% of the set
pressure.
An excessive pressure loss at the inlet of the
overflow valve can cause rapid opening and re-
seating of the valve or chattering.
Chattering results in a reduction in the discharge
capacity and may cause an inadmissible rise in
pressure in the system and damage to the seat
sealing surfaces.
The inlet line must never be smaller than the
nominal diameter of the overflow valve inlet.
Lay supply lines as short as possible.
Install, if at all possible, the valve directly on the
container to be protected.
At least chamfer the container nozzle in the inlet or
even better provide with a radius.
An inlet nozzle with a tapered design has the best
shape in terms of flow.
6.2 Sizing of the outlet line
Outlet lines are to be sized so that reliable functioning
of the valve is ensured under all expected operating
conditions.
The medium is to be discharged so that there is no
risk to people and the environment. The statutory
provisions (e.g. accident prevention regulations, and
the equivalents of the German Pollution Control Act or
the German Clean Air Code) as well as local
regulations (works standards) are to be observed.
There must be no possibility of the overflow valves
becoming ineffective due to shut-off elements.
6.2.1 Admissible back pressure
The outlet line must never be smaller than the
nominal diameter of the overflow valve outlet.
The admissible back pressure in the valve outlet
must not be exceeded in order to prevent destruc-
tion of the bellows or a reduction in the discharge
capacity.
The Pressure-temperature-diagram in Section 1.4
contain information of the manufacturer on admissible
back pressures.
6.2.2 Drainage of condensate
Lay horizontal pipes with a gradient away from the
valve so that the liquid medium cannot accumulate in
the valve body and that, in the case of gases, no
condensate collects in the body.
If outlet lines are laid with a geodetic level difference
(e.g. for vapours or gases with a 90° vertical upright
pipe bend out of the valve), the bend must not be
located directly downstream of the valve.
wrong
Fig. 3
A horizontal pipe section with a gradient must firstly
be installed downstream of the valve.
A draining facility must be provided at the lowest point
in the pipe. This opening for the drainage of conden-
sate must be lower than the flow chamber of the body.
right
Fig. 4
- Overflow and pressure relief 1
- List of Contents 2
- Relevant documents 2
- 1 Technical data 3
- Series GUT/F Page 4 4
- 1.2 Tightening torques 4
- 2 Safety 5
- Series GUT/F Page 6 6
- 3.1 Intended use 6
- Series GUT/F Page 7 7
- 5.2 Storage 7
- 5.3 Return consignments 7
- 5.4 Disposal 7
- 6 Installation 8
- 7 Operation 10
- 8 Malfunctions 11
- 9 Maintenance 11
- 9530-071-en Revision 10 12
- TM 8361 Edition 10/2011 12
- 10 Drawings 13
- Series GUT/F Page 14 14
- 10.2 Sectional drawing 14
- Series GUT/F Page 15 15
- 10.4 Dimensional drawing 15
- A Unit of IDEX Corporation 16
- Richter Pumps, -Valves 19
- () () - () () () 20
Manuais e produtos relacionados com Acessórios para água Richter GUT/F Series Overflow Valves
(26 páginas)
(28 páginas)
(32 páginas)
(32 páginas)
Acessórios para água Richter RSS/F Series Bellows-Sealed Control Valves Manual do Utilizador
(22 páginas)
(22 páginas)
Acessórios para água Richter RSS/F Series Bellows-Sealed Control Valves Manual do Utilizador
(28 páginas)
(28 páginas)
Iomega 34729 Hard Drive 34729 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für NAS & Speicherserver Iomega 34729 Hard Drive 34729.
Wir stellen 1 PDF-Handbücher Iomega 34729 Hard Drive 34729 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentários a estes Manuais